Course 36.2Lesson 3 of 3
A tyre must stretch and spring back for years, and a food tray should rot away after use. This lesson explains natural rubber, why heating it with sulphur makes it tough, the synthetic rubbers, and the polymers that bacteria can break down.
Try the code and the simulations beside the lesson.
Leave a rubber band made of untreated rubber on a hot window sill. It turns soft and sticky. Put it in a freezer and it turns hard and brittle. Natural rubber on its own is not much use. A small change, made by heating it with sulphur, turns it into the rubber of tyres. Let us see why.
Natural rubber comes from latex, a milky liquid from the rubber tree. It is a polymer of isoprene, 2-methylbuta-1,3-diene, . The units join by 1,4-addition: carbon 1 of one unit bonds to carbon 4 of the next. A new double bond forms between carbons 2 and 3:
So each repeat unit, (), keeps one double bond. In natural rubber every double bond has the cis form: the two groups of the chain lie on the same side of it. The chain bends at each unit, so it coils. Only weak van der Waals forces act between the coils. When you pull, the coils straighten. When you let go, they coil again. That is an elastomer.
Gutta-percha has the same formula but every double bond is trans. Its chains are straighter and pack well, so it is hard and not elastic.
Vulcanisation is heating rubber with sulphur and an additive, at 373 to 415 K. The sulphur forms bridges of one or more sulphur atoms between the chains. The bridges form at the carbon atoms next to the double bonds, which are the most reactive sites. Now the chains cannot slide past one another for long. The rubber:
Tyre rubber holds about sulphur. More sulphur gives more bridges and a harder material. With a very large amount, the rubber becomes a hard, black solid that was once used for the cases of batteries.
| Rubber | Monomers | Good for |
|---|---|---|
| Neoprene | chloroprene | oil-proof hoses |
| Buna-N | butadiene, acrylonitrile | oil seals |
| Buna-S | butadiene, styrene | tyres, soles |
Neoprene is polychloroprene. Chloroprene is 2-chlorobuta-1,3-diene, , and it is joined by a free-radical chain. The repeat unit is . It resists vegetable and mineral oils: conveyor belts, gaskets and hoses.
Buna-N is a copolymer of buta-1,3-diene and acrylonitrile, made with a peroxide catalyst. The polar nitrile groups make it resist petrol, lubricating oil and organic solvents: oil seals and the lining of tanks.
Buna-S is a copolymer of buta-1,3-diene and styrene. The name comes from butadiene and Na, the symbol of sodium, which was the first catalyst. It is used for car tyres, floor tiles, footwear and cable insulation.
In each of these, the butadiene part joins by 1,4-addition and becomes .
Polythene and PVC lie in the soil for hundreds of years, because no living thing can break their chains. A biodegradable polymer has links that water and enzymes can attack, usually ester or amide links.
Set the sulphur to with bridges of two atoms. About 6.6 units in every 100 are tied to another chain. Now make the bridges longer. The same sulphur makes fewer bridges.
The program works out the number of isoprene units in a rubber chain, the bromine that its double bonds take up, and the sulphur bridges in a vulcanised sample.
Try each one on your own first. If you are stuck, open a hint. Then check with Show the answer.
Every lesson is open to read. Enrolling also lets you:
Log in to join the discussion.
Loading…
This lesson is free to read. Enroll free to keep your place and take the tests.