Course 37.3Lesson 3 of 3
Most of the waste of a chemical plant is solvent, and much of its energy goes into heating. This lesson looks at greener solvents, from water to supercritical carbon dioxide, at catalysts, and at the strange chemistry of particles only a few nanometres across.
Try the code and the simulations beside the lesson.
Ask a chemical engineer where the waste of a plant goes. Often the answer is: into the solvent. A reaction may need ten times its own mass of solvent, and more for washing and purifying. Many old solvents, such as benzene, tetrachloromethane and dichloromethane, are toxic, burn easily or harm the ozone layer.
The greenest solvent is no solvent at all: some reactions run in the melt, or by grinding solids together. When a solvent is needed, these are greener choices:
Every gas has a critical point. Above its critical temperature, no pressure can turn the gas into a liquid. Above both the critical temperature and the critical pressure, the substance is a supercritical fluid. It flows like a gas but dissolves things like a liquid.
For carbon dioxide the critical point is () and . These are easy to reach. Supercritical carbon dioxide takes the caffeine out of coffee beans, cleans electronic parts and extracts flavours. When the pressure is released, it becomes a gas and leaves the product clean. It is collected and used again.
A catalyst is used in small amounts and comes back unchanged. It saves reagents and often lets a reaction run at a lower temperature, which saves energy. Enzymes, the catalysts of living things, work in water near room temperature with very high selectivity. Heating by microwaves or using light can also cut the energy used.
Compare two oxidations. With potassium dichromate, the chromium ends up as chromium(III) waste, which must be treated. With hydrogen peroxide or oxygen and a catalyst, the by-product is water.
A nanometre is , about the width of a few atoms. Nanoparticles are 1 to 100 nm across. At this size a solid behaves differently, for two reasons.
1. Much of it is surface. Cut a cube in half three ways and you get eight small cubes, with twice the surface. For spheres of diameter and density , the surface area of one gram is
With in g/cm3 and in nm, this is in m2/g. A gram of gold spheres 10 nm across has a surface of about 31 m2. Since reactions happen at surfaces, nanoparticles make very active catalysts.
2. The share of surface atoms is large. If the atoms are across, the outer layer of a sphere is a shell of thickness . The share of the atoms in it is .
For gold, with atoms 0.288 nm across, a 10 nm particle has 16.3 % of its atoms at the surface, and a 2 nm particle about 64 %. Bulk gold is unreactive. Gold particles a few nanometres across catalyse the oxidation of carbon monoxide at room temperature.
Size changes colour and other properties. Gold nanoparticles in water look ruby red, not gold. Tiny crystals of semiconductors, called quantum dots, give out light whose colour depends on their size: smaller dots give bluer light. The melting point of a very small particle is lower than that of the bulk solid.
Making nanoparticles.
Uses. Platinum and palladium particles in catalytic converters; titanium dioxide and zinc oxide particles in clear sunscreens; titanium dioxide on self-cleaning glass, where light makes it break down dirt; silver particles that kill bacteria; carbon nanotubes and graphene for strong, light materials.
Risks. Very small particles can be breathed deep into the lungs and may pass into cells. Their safety is studied for each new use. Green chemistry asks that they be designed to be safe and to break down (principles 4 and 10).
The program works out the surface area of one gram of gold and the share of its atoms at the surface, for particles of many sizes.
Try each one on your own first. If you are stuck, open a hint. Then check with Show the answer.
Every lesson is open to read. Enrolling also lets you:
Log in to join the discussion.
Loading…
This lesson is free to read. Enroll free to keep your place and take the tests.