Electrochemical extraction: aluminium, displacement and chlorine
A modern aluminium cell draws a current of a few hundred thousand amperes, day and night. Why so much electricity? Because no cheap chemical can take oxygen from alumina. This lesson links the Gibbs energy to a cell voltage, follows the Hall-Heroult cell, and shows displacement and the making of chlorine.
about 25 min1 simulation1 practice question
Lesson 1 of 3Show all lessonsHide
Try the code and the simulations beside the lesson.
From Gibbs energy to volts
Some oxides sit so low on the Ellingham diagram that no ordinary reducing agent can break them. Electricity can. In a cell, the Gibbs energy change is linked to the cell potential:
ΔG∘=−nFE∘
Here n is the number of moles of electrons moved in the reaction as written, and F=96485C/mol is the Faraday constant.
If E∘ is positive, ΔG∘ is negative and the reaction runs by itself, as in a battery or a displacement.
If E∘ is negative, the reaction is uphill. An outside supply must push it, with a voltage larger than ∣E∘∣. That smallest voltage is the decomposition voltage.
Reactive metals such as sodium, magnesium, calcium and aluminium are won this way, by electrolysis of a molten salt or oxide. Water cannot be used, because hydrogen would come off at the cathode instead of the metal.
The Hall-Heroult cell
Pure alumina melts above 2300 K, which is too hot to work with. So alumina is dissolved in molten cryolite, Na3AlF6, with some calcium fluoride. The mixture melts near 1220 K and conducts well.
A Hall-Heroult cell in section. A steel tank is lined with carbon, which is the cathode and is marked minus. Graphite anode blocks, marked plus, dip from above into a molten bath of alumina dissolved in cryolite at about 1220 K. A layer of molten aluminium collects on the floor of the cell, under the bath, and is tapped off. Bubbles of carbon dioxide and carbon monoxide rise from the anodes.
Cathode: the carbon lining of a steel tank. Molten aluminium collects on the floor and is tapped off.
Anode: graphite blocks dipping into the bath.
At the cathode: Al3+(melt)+3e−→Al(l)
At the anode, the oxide ions are discharged and the oxygen burns the carbon:
C(s)+O2−(melt)→CO(g)+2e− and C(s)+2O2−(melt)→CO2(g)+4e−
Overall: 2Al2O3+3C→4Al+3CO2
The anodes are slowly burnt away and must be replaced. The equation says that 3 mol of carbon go with 4 mol of aluminium, which is 10836=0.33kg of carbon for each kilogram of aluminium. Real cells burn about 0.5 kg, because some carbon leaves as CO and some burns in the air.
Burning the anode also helps. The overall change with carbon has a smaller ΔG∘ than breaking alumina alone, so the decomposition voltage falls from about 2.2 V to about 1.2 V. Real cells run at 4 to 5 V, because the bath and the bubbles resist the current.
Faraday's law in a plant
The mass of metal made follows from the charge, Q=It:
m=nFηIt×M
where η is the current efficiency, the share of the current that really makes metal, and M the molar mass. The energy used is E=UQ, with U the cell voltage.
Set 200 kA, 4.4 V and 93 %. The cell makes about 1.5 tonnes of aluminium a day, at about 14 kWh for each kilogram. That is why aluminium smelters are built beside large power stations.
Displacement
A more reactive metal displaces a less reactive one from a solution of its ions. Copper from a leach liquor is thrown out with scrap iron:
Cu2+(aq)+Fe(s)→Cu(s)+Fe2+(aq)
With E∘(Cu2+/Cu)=+0.34V and E∘(Fe2+/Fe)=−0.44V, the cell potential is +0.78V, so the change runs by itself. Zinc dust displaces gold and silver from their cyanide complexes in the same way.
Chlorine from brine: extraction by oxidation
Metals are won by reduction. A non-metal such as chlorine is won by oxidation of its ion. In brine,
2Cl−(aq)+2H2O(l)→2OH−(aq)+H2(g)+Cl2(g)
has ΔG∘=+422kJ. With n=2, E∘=−2×96485422000=−2.2V. So an outside voltage above 2.2 V is needed. The same cell gives sodium hydroxide and hydrogen. When molten sodium chloride is electrolysed instead, the cathode gives sodium metal.
Practise with new numbers
Try it in Python
The program follows one aluminium cell for one day.
Common mistakes
Using one electron for aluminium.Al3+ takes three.
Calling the steel tank the anode. The carbon lining is the cathode, and the graphite blocks are the anodes.
Forgetting the current efficiency. Some current is lost, so less metal forms than It/nF suggests.
Thinking cryolite is the source of aluminium. It is the solvent. Alumina is used up.
Remember these
ΔG∘=−nFE∘. An uphill change needs a voltage above ∣E∘∣.
Hall-Heroult: alumina in molten cryolite, about 1220 K; carbon lining cathode, graphite anodes; 2Al2O3+3C→4Al+3CO2.
m=ηItM/(nF); energy =UQ.
Displacement: Cu2++Fe→Cu+Fe2+. Chlorine: oxidation of chloride, E∘=−2.2V.
References
NCERT Chemistry Part I for Class 12 (2007 edition), Unit 6, the sections on electrochemical principles of metallurgy and the extraction of aluminium.
OpenStax Chemistry 2e, Chapter 17, sections 17.4 and 17.7 on potential, free energy and electrolysis.
Check yourself
Try each one on your own first. If you are stuck, open a hint. Then check with Show the answer.
Why is alumina dissolved in cryolite instead of being melted on its own?
Why must the graphite anodes of an aluminium cell be replaced from time to time?
A reaction has E∘=−1.50V with n=2. What is ΔG∘, and does it run by itself?
Why can aluminium not be won by electrolysis of an aqueous solution of its salt?
Enroll free in Electrolysis, Refining and the Extraction of Four Metals
Every lesson is open to read. Enrolling also lets you:
Mark lessons done and carry on where you stopped.
Take the tests of this lesson and its course.
Count the course towards the certificate for its chapter.