Convection and thermal radiation · Physics Class 9–10 | StemPy Lab
Course 10.3·Lesson 2 of 3
Convection and thermal radiation
In a liquid or a gas, thermal energy can be carried by the moving fluid itself. Warm fluid is less dense and rises, and cooler fluid sinks, which makes a convection current. Radiation needs no material at all. Every object gives out infrared radiation, and black, dull surfaces give out and take in the most.
about 35 min1 simulation2 practice questions1 Python program5 questions to check yourself
This lesson is free to read. Enroll free to keep your place in the course.
Lesson 2 of 3Show all lessonsHide
Try the code and the simulations beside the lesson.
Why does warm air rise?
Hold your hand above a candle. You feel the heat, even though air is a poor conductor. The air above the flame is carrying the energy upwards. This is convection.
Convection is the transfer of thermal energy by the movement of a liquid or a gas. It is an important way of moving energy in liquids and gases, and it cannot happen in a solid, whose particles stay in their places.
Explaining convection
Part of a fluid is heated. Its particles move faster and push further apart.
This part expands. The same mass fills a bigger volume, so the fluid is less dense.
The warmer, less dense fluid is pushed up by the cooler, denser fluid around it.
The cooler fluid sinks and takes its place. It is heated in turn.
A loop forms. This loop is a convection current.
Two pictures of convection currents. On the left is a beaker of water heated by a flame under one corner, with a purple crystal of potassium permanganate at the bottom. A purple stream rises above the flame, spreads along the top, sinks on the far side and returns along the bottom. On the right is a room with a radiator low on the left wall. Arrows show warm air rising from the radiator to the ceiling, moving across the top of the room, sinking on the cold right side and returning to the radiator along the floor.
A worked example with numbers: the density of air at 20∘C is about 1.20kg/m3. At 60∘C it is about 1.06kg/m3. A room has a volume of 40m3.
Mass at 20∘C.m=ρV=1.20×40=48.0kg.
Mass at 60∘C.m=1.06×40=42.4kg.
The meaning. When the room warms, 5.6 kg of air leaves through the gaps, so the air that is left is less dense. Inside a fluid that cannot leave, the cooler fluid around a warm part pushes it upwards.
Experiments on convection
Potassium permanganate in water. Drop a crystal of potassium permanganate to the bottom of a beaker of water. Heat the water just under the crystal. The purple colour rises above the flame, spreads at the top, and sinks on the far side. The coloured stream shows the convection current.
A smoke box. A box with a glass front has two chimneys. A candle is lit under one chimney. Smoke from a smouldering paper held over the other chimney is drawn down it, passes across the box and goes up the candle chimney. The warm air above the candle rises, and cooler air flows in to replace it.
Thermal radiation
Stand in front of a fire. The side of your face towards the fire feels warm. Air is a poor conductor, and the warm air rises away from you, so conduction and convection do not bring the energy to your face. It travels as thermal radiation.
Thermal radiation is infrared radiation, a part of the family of electromagnetic waves.
All objects emit it, hot or cold, but hotter objects emit more.
It does not need a medium. It crosses empty space. The energy of the Sun reaches the Earth in this way.
A worked example: Infrared radiation from the Sun travels at 3.0×108 m/s. The distance from the Sun to the Earth is 1.5×1011 m, so the time is 3.0×108m/s1.5×1011m=500s, which is 8.3 minutes.
Surfaces and radiation
The kind of surface decides how much radiation it emits, absorbs and reflects.
Surface
Emits
Absorbs
Reflects
Dull black
Best
Best
Worst
Shiny white or silver
Worst
Worst
Best
So a dull black saucepan loses energy by radiation faster than a shiny one. A black roof gets warmer in the Sun than a white roof. For infrared, the difference between dull and shiny is bigger than the difference between black and white, but the table above is the rule you should use.
Look at the curves. The dull black can cools faster. That is because it emits more radiation than the shiny can. After 30 minutes the black can is at 38.1∘C and the shiny one at 60.8∘C.
Experiments on emitters and absorbers
Experiment 1: good and bad emitters. A Leslie cube is a metal cube with four faces of different surfaces: dull black, shiny silver, dull white and shiny black. Fill it with hot water, so that all faces are at the same temperature. Place an infrared detector the same distance from each face in turn, and read it. The dull black face gives the biggest reading, and the shiny silver face the smallest.
A diagram of a Leslie cube, a metal cube filled with hot water. Its four vertical faces are different: one is dull black, one is shiny silver, one is dull white and one is shiny black. An infrared detector on a stand is placed at the same distance from one face and reads the radiation. Next to it a table lists the readings for the four faces. The dull black face gives the largest reading and the shiny silver face gives the smallest.
A simpler way is to fill two identical cans, one dull black and one shiny, with the same volume of hot water, and to record the temperature every minute. The can that cools faster is the better emitter.
Experiment 2: good and bad absorbers. Place two identical metal plates, one dull black and one shiny, the same distance from a heater. Fix a drawing pin to the back of each with wax, or put a thermometer on each. The wax melts first on the black plate, which shows that it absorbs best. Make sure that the heater is the same distance from each plate.
Extended: the rate of emission depends on the surface temperature and the surface area of the object. A hotter object emits more every second. A bigger area emits more every second, if the temperature and the surface are the same.
Practise with new numbers
Try it in Python
The program follows the temperature of a dull black can and a shiny can of hot water in the same room. It uses a model: the can loses a fixed fraction of its excess over the room each minute.
Common mistakes
Saying that convection happens in solids. It needs a fluid that can flow.
Saying that hot air rises because heat rises. Hot air rises because it is less dense than the cooler air around it.
Thinking that radiation needs air. It crosses a vacuum. The Sun's energy reaches us across space.
Thinking that only hot objects radiate. All objects emit infrared radiation. Hotter objects emit more.
Mixing up emitters and absorbers. Dull black surfaces are the best at both. Shiny white or silver surfaces are the worst at both and the best at reflecting.
Remember these
Convection: movement of a liquid or gas carries thermal energy. Warm fluid expands, is less dense and rises. Cool fluid sinks.
Convection experiments: purple crystal in a heated beaker, a smoke box with a candle.
Thermal radiation is infrared. All objects emit it. It needs no medium.
Dull black surfaces emit and absorb best. Shiny white or silver surfaces emit and absorb worst and reflect best.
Extended: the rate of emission is bigger for a higher surface temperature and a bigger surface area.
Check yourself
Try each one on your own first. If you are stuck, open a hint. Then check with Show the answer.
Explain why a convection current forms in a beaker of water heated at the bottom.
Sunlight crosses space to reach a planet that is 150 million km from the Sun. How long does the radiation take, in seconds, if it travels at 3.0×108 m/s?
Which is the better absorber of infrared radiation, a dull black surface or a shiny white surface?
Extended. A hot object has a large area and a high surface temperature. How does this affect the rate at which it emits infrared radiation?
References
Cambridge IGCSE Physics 0625 syllabus, sections 2.3.2 and 2.3.3: convection and radiation.
OpenStax, College Physics 2e, Chapter 14 (Heat and Heat Transfer Methods): convection and radiation.
Enroll free in Moving Thermal Energy
Every lesson is open to read. Enrolling also lets you:
Mark lessons done and carry on where you stopped.
Count the course towards the certificate for its chapter.