Course 13.1Lesson 2 of 3
A clock tells you the time of a long event. For a very short event, or a very small thickness, one measurement is not good enough. We measure many of them together and divide, so the error is shared out.
Try the code and the simulations beside the lesson.
A clock shows the time of day. For short events in a laboratory we use a stopwatch or a digital timer. A good stopwatch shows 0.01 s. A person who starts and stops it by hand is slower than that. The delay in the reaction of the person is about 0.2 s. We call it the reaction time.
A timer that is started and stopped by a beam of light, called a light gate, has no reaction time. We use a stopwatch when we have no such device, and we plan the experiment to reduce the error.
Suppose you want the thickness of one sheet of paper. A ruler shows only whole millimetres, and the sheet is much thinner than that. But a stack of 200 sheets measures 21.0 mm. One sheet is .
The idea is the same for a small distance or a short time: measure a multiple and divide. We can find the diameter of a wire by winding it round a pencil. We count the turns, measure the length of the coil, and divide.
A pendulum is a small mass, called a bob, on a thread. It swings to and fro. One complete oscillation is one swing from the start, across to the other side and back to the start again. The period is the time for one complete oscillation.
One swing of a pendulum is too quick to time by hand. So we time oscillations and divide:
Here is the total time and is the number of complete oscillations. We start the count at zero when the bob passes the middle, and we start the stopwatch at the same moment.
Why does this help? The reaction error of 0.2 s happens once at the start and once at the end, and the total error is about the same however many swings we count. When we divide by , the error in the period is only seconds.
Slide the number of swings up. The error in one period becomes smaller. Count 1 swing and the error is large. Count 20 swings and it is small.
Repeat the whole measurement and take the mean (average). Add the readings and divide by how many you have. If one reading is far from the others, it is an anomalous result. You ignore it, and say that you did.
A worked example. A pupil times 20 swings three times: s, s and s.
The program takes four timings of 20 swings, drops the anomalous one, and finds the period and its error.
Try each one on your own first. If you are stuck, open a hint. Then check with Show the answer.
Every lesson is open to read. Enrolling also lets you:
Log in to join the discussion.
Loading…
This lesson is free to read. Enroll free to keep your place in the course.