A copper kettle is hard and heavy, copper sulfate crystals are blue, and a balloon of helium floats and never burns. In this lesson we look at the metals in the middle of the Periodic Table, and then at the gases at the far right.
about 30 min1 simulation2 practice questions
Lesson 3 of 3Show all lessonsHide
Try the code and the simulations beside the lesson.
The transition elements
Between Group II and Group III of the Periodic Table there is a block of metals called the transition elements. Iron, copper, nickel, chromium and manganese are examples. They are metals, so they conduct heat and electricity. The Core syllabus lists four properties that mark them out.
They have high densities.
They have high melting points.
They form coloured compounds.
They often act as catalysts, both as elements and in compounds.
High densities and high melting points
Compare them with the Group I metals, which are soft and have low melting points and low densities.
Metal
Melting point
Density
Sodium
98∘C
0.97g/cm3
Potassium
63∘C
0.86g/cm3
Iron
1538∘C
7.87g/cm3
Copper
1085∘C
8.96g/cm3
Nickel
1455∘C
8.91g/cm3
Two bar charts side by side that compare five metals. The left chart shows the melting point in degrees Celsius: sodium 98, potassium 63, iron 1538, copper 1085 and nickel 1455. The right chart shows the density in grams per cubic centimetre: sodium 0.97, potassium 0.86, iron 7.87, copper 8.96 and nickel 8.91. The three transition metals have much taller bars than the two Group I metals in both charts.
Sodium floats on water, because its density is less than 1g/cm3. Iron and copper sink at once. Iron and copper are also much less reactive than sodium. They do not react with cold water.
Coloured compounds
Compounds of Group I metals are usually white. Compounds of the transition elements are often coloured. You will meet these in the tests for ions.
Copper(II) compounds are blue. Copper(II) sulfate solution is blue, and copper(II) hydroxide is a light blue precipitate.
Iron(II) hydroxide is a green precipitate.
Iron(III) hydroxide is a red-brown precipitate.
Chromium(III) hydroxide is a green precipitate.
Potassium manganate(VII) is purple.
Catalysts
A catalyst increases the rate of a reaction and is unchanged at the end of the reaction. Transition elements and their compounds are often good catalysts.
Iron is the catalyst in the Haber process, which makes ammonia.
Vanadium(V) oxide is the catalyst in the Contact process, which makes sulfur trioxide.
Nickel is the catalyst when hydrogen is added to alkenes.
Manganese(IV) oxide is a catalyst for the decomposition of hydrogen peroxide into water and oxygen.
Extended: variable oxidation numbers
A transition element can form more than one ion. Iron forms Fe2+ and Fe3+. A Group I metal always forms a 1+ ion, and a Group II metal always forms a 2+ ion. The Roman numeral in the name shows the oxidation number of the metal, which is the charge on the ion.
Iron(II) chloride, FeCl2, contains Fe2+ and Cl− ions.
Iron(III) chloride, FeCl3, contains Fe3+ and Cl− ions.
Iron and dilute hydrochloric acid make iron(II) chloride and hydrogen. Iron and chlorine make iron(III) chloride, 2Fe+3Cl2→2FeCl3. Both reactions use one metal, but the iron loses two electrons in one and three in the other.
Practise with new numbers
The noble gases
Group VIII of the Periodic Table holds the noble gases: helium, neon, argon, krypton, xenon and radon. They are unreactive, monatomic gases. Monatomic means that each particle is a single atom. A helium balloon contains separate He atoms, not molecules.
The reason is the electronic configuration. Look at the first three.
Electron shell diagrams of helium, neon and argon. Helium has one shell with 2 electrons. Neon has two shells, with 2 and 8 electrons. Argon has three shells, with 2, 8 and 8 electrons. In each atom the outer shell is full, so the atom does not need to gain, lose or share electrons. Each atom is drawn alone, because noble gases are monatomic.
Helium has 2 electrons, so its only shell is full.
Neon has 2, 8 electrons. The outer shell is full.
Argon has 2, 8, 8 electrons. The outer shell is full.
An atom with a full outer shell has no need to gain, lose or share electrons. So it forms no ions and no bonds under ordinary conditions. This is why the noble gases are unreactive.
Because the noble gases do not react, argon fills filament lamps so that the hot filament does not burn. Helium fills balloons, because it is less dense than air and does not catch fire. The boiling points rise down the group, from helium at 4K to xenon at 165K.
Try it in Python
The program sorts metals by their melting point and density.
Common mistakes
Saying that noble gases form molecules. They are monatomic, so each particle is one atom.
Saying that noble gases are unreactive because they have eight outer electrons. Helium has only 2, and its shell is full. A full shell is the reason.
Using the Group I pattern for the transition elements. The transition elements are hard and dense, not soft and light.
Forgetting that a catalyst is unchanged. It speeds up the reaction but its mass is the same at the end.
Writing iron chloride without a number. Iron forms two chlorides, so the name needs (II) or (III).
Remember these
The transition elements are metals with high densities and high melting points. They form coloured compounds and are often catalysts.
Examples of catalysts: iron in the Haber process, vanadium(V) oxide in the Contact process, nickel for adding hydrogen.
Extended: a transition element can have ions with different oxidation numbers, such as Fe2+ and Fe3+.
The noble gases are monatomic, unreactive gases because their outer shell is full.
Check yourself
Try each one on your own first. If you are stuck, open a hint. Then check with Show the answer.
Give two physical properties that make iron different from sodium.
Name the catalyst in the Haber process.
Why is neon unreactive?
Extended: write the formulas of iron(II) chloride and iron(III) chloride, and give the charge on the iron in each.
A student adds manganese(IV) oxide to hydrogen peroxide. Bubbles of gas appear. What happens to the mass of manganese(IV) oxide, and why?
References
Cambridge IGCSE Chemistry 0620 syllabus for 2026 to 2028, section 8.4 (Transition elements), Core 1 and Supplement 2, and section 8.5 (Noble gases), Core 1.
OpenStax, Chemistry 2e, Chapter 19 (Transition Metals and Coordination Chemistry), and Chapter 18, the section on the noble gases.
Enroll free in Halogens, Transition Elements and Noble Gases
Every lesson is open to read. Enrolling also lets you:
Mark lessons done and carry on where you stopped.
Take the tests of this lesson and its course.
Count the course towards the certificate for its chapter.