Course 40.3Lesson 2 of 3
Sea salt is made by letting sea water dry in the sun, and drinking water can be made by boiling sea water and cooling the steam. Both are separations. This lesson covers filtration, crystallisation, the kinds of distillation, sublimation and solvent extraction, with the numbers that tell a chemist how well each one works.
Try the code and the simulations beside the lesson.
Filtration separates a solid from a liquid. A gravity filter uses a folded paper in a funnel. A suction filter uses a flat paper in a Büchner funnel, with a pump that pulls the liquid through. It is faster and leaves a drier solid. Wash the solid with a little cold solvent, so that little of it dissolves.
To get a solid out of a solution, we evaporate some of the solvent and let the solution cool. Crystals form as the solid becomes less soluble.
Recrystallisation purifies a solid. A good solvent dissolves the solid well when hot and poorly when cold. The impurities should stay dissolved when cold, or not dissolve at all, so that they can be filtered off hot.
Some of the solid always stays in the cold solvent. That is why we use the least volume of hot solvent.
Benzoic acid is a good example. About 6.8 g of it dissolves in 100 cm³ of water near 95 °C, but only about 0.34 g at 25 °C. So water is a good solvent for it.
Simple distillation separates a liquid from a dissolved solid, or two liquids whose boiling points differ by a lot.
Fractional distillation separates liquids whose boiling points are close. A fractionating column sits between the flask and the condenser. Vapour condenses and boils again many times on the beads or plates of the column. Each time, the vapour gets richer in the more volatile liquid.
Why does the vapour get richer? For an ideal mixture, Raoult's law gives each partial pressure: . The liquid with the higher vapour pressure makes up more of the vapour than of the liquid. The thermometer bulb sits level with the side arm, so it reads the temperature of the vapour that leaves.
Distillation under reduced pressure lowers the boiling point. It is used for liquids that break down at their normal boiling point, such as glycerol.
Steam distillation is used for a liquid that does not mix with water and is volatile in steam, such as aniline or the oils of plants. Two liquids that do not mix each give their own full vapour pressure. The mixture boils when
So it boils below 100 °C, and the compound distils without decomposing. The masses in the distillate are in the ratio
Some solids turn straight into vapour on heating, such as iodine, naphthalene, camphor and ammonium chloride. Heating a mixture of such a solid with sand or salt drives it off. It forms solid again on a cold surface.
Shake a solution with a second solvent that does not mix with it, in a separating funnel. The solute shares itself between the two layers. The ratio of its concentrations is the partition coefficient:
After one shake with a volume of solvent, the fraction left in a volume of water is . After shakes, each with ,
Several small portions take out more than one large portion of the same total volume. Indian books call this differential extraction.
Set K = 4 and 60 cm³ in all. One portion takes out about 71 %. Three portions of 20 cm³ take out about 83 %.
Acid and base extraction. A carboxylic acid dissolved in ether moves into aqueous sodium hydrogencarbonate as its sodium salt. A neutral compound stays in the ether. Adding acid to the water layer then gives back the carboxylic acid.
The program compares one extraction with several, for the same total volume of solvent.
Try each one on your own first. If you are stuck, open a hint. Then check with Show the answer.
Every lesson is open to read. Enrolling also lets you:
Log in to join the discussion.
Loading…
This lesson is free to read. Enroll free to keep your place and take the tests.