Course 40.3Lesson 3 of 3
A drop of black ink on wet paper spreads into rings of blue, red and yellow. The colours were in the ink all along, and the water carried them different distances. This lesson covers paper, thin-layer, column and gas chromatography, and how a chemist checks purity by a melting point.
Try the code and the simulations beside the lesson.
Every kind of chromatography has two phases. The stationary phase stays still: the paper, a thin layer of silica on a plate, or the packing of a column. The mobile phase moves through it: a solvent or a gas. A compound that clings to the stationary phase moves slowly. One that prefers the mobile phase moves fast. So the compounds of a mixture separate.
The retardation factor is
Here is the distance moved by the spot and the distance moved by the solvent. Both distances are measured from the baseline, to the centre of the spot. An Rf is always between 0 and 1. It depends on the compound, the solvent and the plate, so we compare a mixture with references run on the same plate.
On silica, a polar compound clings more and has a smaller Rf. A more polar solvent moves every spot further.
Two-way chromatography. If two compounds share an Rf in one solvent, turn the plate through 90° and run it again in a second solvent.
A glass column is packed with silica or alumina. The mixture goes on top, and solvent runs down through it. The least polar compound comes out first, the most polar last. Each part that comes out is collected in its own flask. This works on a larger scale than a plate.
In gas chromatography (GC) the mobile phase is a gas, such as helium or nitrogen, and the stationary phase is a liquid coated inside a long, thin column. Each compound comes out after its own retention time. The area of each peak is proportional to the amount of the compound, once each is corrected by its response factor. A-Level and IB use GC to find the composition of a mixture. High-performance liquid chromatography (HPLC) works the same way with a liquid under pressure.
Let the solvent run further. The gap between two spots grows in proportion to the distance run, so a longer plate separates better.
A pure solid melts sharply, over 1 °C or less, at a fixed temperature. An impurity does two things:
Mixed melting point. To check that a product is compound Y, mix it with a pure sample of Y. If the melting point stays the same, the product is Y. If it falls, the product is something else.
For a small amount of impurity, the fall in the melting point is
Here is the melting point of the pure solid in kelvin, is its enthalpy of fusion, and is the mole fraction of the impurity. Olympiad problems use this to estimate purity. A liquid is checked in the same way by its boiling point.
The program turns the areas of gas chromatography peaks into a percentage composition.
Try each one on your own first. If you are stuck, open a hint. Then check with Show the answer.
Every lesson is open to read. Enrolling also lets you:
Log in to join the discussion.
Loading…
This lesson is free to read. Enroll free to keep your place and take the tests.