Aromatic routes and changing the length of the carbon chain
Benzene does not add bromine the way ethene does, so its routes are different. This lesson builds the map of benzene, nitrobenzene, aniline and the diazonium salt, and the reactions that make a carbon chain one carbon longer or one carbon shorter.
about 25 min1 simulation1 practice question
Lesson 3 of 3Show all lessonsHide
Try the code and the simulations beside the lesson.
The benzene ring prefers substitution
The ring of benzene is very stable. Strong electrophiles replace a hydrogen on it and keep the ring whole. So most aromatic routes begin with an electrophilic substitution.
Nitration: concentrated nitric acid and concentrated sulphuric acid, kept between 323 and 333 K. C6H6+HNO3→C6H5NO2+H2O
Halogenation:Br2 or Cl2 with iron(III) bromide, iron(III) chloride or aluminium chloride, in the dark.
Friedel-Crafts alkylation: a chloroalkane with anhydrous aluminium chloride. C6H6+CH3Cl→C6H5CH3+HCl
Friedel-Crafts acylation: an acyl chloride with anhydrous aluminium chloride. C6H6+CH3COCl→C6H5COCH3+HCl
A map of benzene routes. Benzene to nitrobenzene with concentrated HNO3 and H2SO4 below 333 K. Nitrobenzene to aniline with Sn and HCl, then NaOH. Aniline to benzenediazonium chloride with NaNO2 and HCl at 273 to 278 K. From the diazonium salt: phenol with warm water, chlorobenzene with CuCl, bromobenzene with CuBr, benzonitrile with CuCN, iodobenzene with KI. Benzene to methylbenzene with CH3Cl and AlCl3, then to benzoic acid with KMnO4 and heat, then acid. Benzene to phenylethanone with CH3COCl and AlCl3.
The nitrogen road
The most useful route on the aromatic map goes through nitrogen.
Benzene to nitrobenzene: nitration.
Nitrobenzene to aniline (phenylamine): tin and concentrated hydrochloric acid, heat, then sodium hydroxide to free the amine from its salt.
Aniline to benzenediazonium chloride: sodium nitrite and hydrochloric acid at 273 to 278 K. Above about 283 K the diazonium salt breaks down.
The diazonium group, -N2+, is a superb leaving group, because it leaves as nitrogen gas. So many groups can take its place.
Warm with water: phenol.
Copper(I) chloride in HCl: chlorobenzene. Copper(I) bromide in HBr: bromobenzene. This is the Sandmeyer reaction.
Copper(I) cyanide: benzonitrile, with one carbon more on the ring.
Potassium iodide: iodobenzene.
Phosphinic acid, H3PO2: benzene again. This removes an amino group after it has done its job.
An alkaline solution of phenol, cold: an orange azo dye, by coupling. Here the nitrogen stays.
Groups that guide the next group
A group already on the ring decides where the next one goes.
2- and 4-directing (also called ortho and para): -CH3, -OH, -NH2, -OCH3 and the halogens.
So the order of the steps matters. Nitrate benzene and then brominate it: you get 1-bromo-3-nitrobenzene. Brominate first and then nitrate: you get mainly 1-bromo-4-nitrobenzene. The next course comes back to this.
The side chain
An alkyl group on a ring, of any length, is oxidised to one COOH group by hot alkaline potassium manganate(VII), then acid. The carbon next to the ring must carry at least one hydrogen. So ethylbenzene and propylbenzene both give benzoic acid.
A longer chain or a shorter one
Count the carbons before you plan. Here are the steps that change the count.
One carbon more
Haloalkane with KCN in ethanol: a nitrile. RBr→RCN
Aldehyde or ketone with HCN and a little KCN: a 2-hydroxynitrile.
Diazonium salt with CuCN: an aryl nitrile.
A Grignard reagent, RMgBr made from RBr and magnesium in dry ether, with carbon dioxide, then acid: RCOOH.
A Grignard reagent with methanal, then acid: RCH2OH.
One carbon fewer
Amide with bromine and sodium hydroxide (the Hofmann bromamide reaction): RCONH2→RNH2.
Sodium salt of an acid heated with soda lime (NaOH with CaO): decarboxylation. RCOONa+NaOH→RH+Na2CO3
Two chains joined
A Grignard reagent with an aldehyde gives a secondary alcohol, and with a ketone a tertiary alcohol. The two carbon skeletons join at the old C=O carbon.
Friedel-Crafts reactions join a chain to a ring.
Choose benzamide. The amine, aniline, weighs less than the amide, because the CO group leaves as carbonate.
Practise with new numbers
Try it in Python
The program follows the number of carbon atoms along a five-step route.
Common mistakes
Nitrating aniline directly. Nitric acid oxidises it, and the anilinium ion directs to the 3-position. Protect the amino group first, as the next course shows.
Warming a diazonium salt too early. Keep it at 273 to 278 K until you add the next reagent.
Thinking a long side chain gives a long acid. Every alkyl side chain gives benzoic acid.
Friedel-Crafts on nitrobenzene. A ring that carries a nitro group is too unreactive.
Making a Grignard reagent in wet ether. Water destroys it, giving the alkane.
References
NCERT Chemistry Part II for Class 12, Unit 13 (Amines, the diazonium salts) and Unit 12 (Hofmann, decarboxylation, Grignard).
NCERT Chemistry Part II for Class 11, Unit 13, Hydrocarbons (electrophilic substitution, directing groups).
Check yourself
Try each one on your own first. If you are stuck, open a hint. Then check with Show the answer.
Give a route from benzene to phenol through the diazonium salt, with the reagent and condition of each step.
Which two steps make benzoic acid from bromobenzene with the carbon count growing by one?
Propanoic acid is turned into its sodium salt and heated with soda lime. Which gas comes off?
Why can methylbenzene not be made from nitrobenzene by a Friedel-Crafts reaction?
Enroll free in Functional Group Interconversions: Reagents, Conditions and Maps of Reactions
Every lesson is open to read. Enrolling also lets you:
Mark lessons done and carry on where you stopped.
Take the tests of this lesson and its course.
Count the course towards the certificate for its chapter.