Why does a slice of cucumber in salt water go soft, while a raisin in plain water swells? This lesson defines water potential and its two parts, shows how to work out the way water moves between cells, and explains plasmolysis, turgor and imbibition.
about 30 min1 simulation1 practice question
Lesson 2 of 3Show all lessonsHide
Try the code and the simulations beside the lesson.
The energy of water
Drop a raisin into a glass of water. After a few hours it is plump. Put a slice of cucumber in strong salt water. It goes soft and bendy. In both, water has moved across cell membranes. Which way it moves depends on one quantity, water potential.
Water potential, written ψw (the Greek letter psi), measures the free energy of water in a system. The water potential of pure water at the pressure of the air is set at zero. Water always moves from a region of higher water potential to a region of lower water potential.
Water potential is measured in units of pressure. Plant biologists use the megapascal (MPa). One megapascal is 106 pascals, about ten times the pressure of the air.
Two parts of water potential
Two things change the water potential of a cell.
ψw=ψs+ψp
Solute potentialψs. Dissolving solutes lowers the free energy of water. So ψs is always negative, and the more solute, the more negative it is. It is also called the osmotic potential.
Pressure potentialψp. Pressure on water raises its water potential. In a turgid cell the wall presses back on the contents, so ψp is positive. In the xylem of a transpiring plant the water is pulled, so ψp there is negative.
For a dilute solution, the solute potential is
ψs=−iCRT
Here C is the concentration in mol/L, T is the temperature in kelvin, R=0.00831L MPa mol−1K−1, and i is the number of particles that each formula unit gives. For sucrose i=1. For sodium chloride, which splits into two ions, i is close to 2.
Try it for 0.1mol/L sucrose at 298K: ψs=−1×0.1mol/L×0.00831L MPa mol−1K−1×298K=−0.248MPa.
Some books, including NCERT, speak of osmotic pressure. It is the pressure needed to stop water entering a solution, and it equals −ψs. A solution with an osmotic pressure of 0.248MPa has ψs=−0.248MPa.
Notice that at zero concentration and zero pressure, the point sits on the zero line: pure water.
Osmosis between two cells
Osmosis is the movement of water across a selectively permeable membrane, from higher to lower water potential. Here is a worked example.
A cell X has ψs=−0.8MPa and ψp=0.3MPa. So ψw=−0.8MPa+0.3MPa=−0.5MPa. Its neighbour Y has ψs=−1.0MPa and ψp=0.3MPa, so ψw=−0.7MPa. Which way does water move? From X (−0.5MPa) to Y (−0.7MPa), because −0.5 is higher than −0.7.
Notice the trap. You must compare the water potentials, not the solute potentials or the pressures alone.
Plasmolysis
The words hypotonic, isotonic and hypertonic compare a solution with a cell. A hypotonic solution has a higher water potential than the cell; a hypertonic one has a lower water potential.
Three plant cells side by side. Left, in a dilute solution (hypotonic): the cell is turgid, its vacuole is large and the cytoplasm presses on the wall. Middle, in a solution of the same water potential (isotonic): the cell is flaccid, the cytoplasm just touches the wall, the stage of incipient plasmolysis. Right, in a strong solution (hypertonic): the protoplast has shrunk away from the wall into a rounded mass, and the space between the wall and the protoplast is filled with the outside solution. Arrows show water moving in on the left and out on the right.
In a hypotonic solution water enters the cell. The vacuole swells and the protoplast presses on the wall. The cell is turgid. The wall presses back, so the cell does not burst. An animal cell, with no wall, would burst.
In an isotonic solution there is no net movement. The cell is flaccid.
In a hypertonic solution water leaves the cell. The protoplast shrinks away from the wall. This is plasmolysis. The wall lets the solution through freely, so the space between the wall and the shrunken protoplast fills with the outside solution.
The stage at which the protoplast just begins to pull away from the wall is called incipient plasmolysis. There, the wall no longer presses on the contents, so ψp=0 and ψw=ψs. This gives a way to measure the solute potential of a cell: find the solution that just causes incipient plasmolysis.
If a plasmolysed cell is put back in water, it takes up water and recovers. This is deplasmolysis.
Imbibition
A dry seed put in water swells hugely. Dry wood swells in rain and makes a door stick. This is imbibition: water is absorbed by solid materials such as cellulose, starch and proteins. It is a special kind of diffusion, down a gradient of water potential, because dry material has a very low water potential. Imbibing seeds develop a large pressure, which helps the seedling push up through the soil.
Try it in Python
The program works out the water potential of two cells and the way water moves between them.
Practise with new numbers
Common mistakes
Thinking water moves to the higher number. Water moves to the lower (more negative) water potential.
Comparing solute potentials only. Add the pressure potential first.
Giving ψs a positive sign. Solutes always make it negative.
Saying the space in a plasmolysed cell is empty, or holds air. It holds the outside solution, which passes through the wall.
Forgetting i for salts. Sodium chloride gives about twice as many particles as sucrose at the same concentration.
Remember these
Pure water: ψw=0. Water moves from higher to lower ψw.
ψw=ψs+ψp; ψs=−iCRT.
Hypertonic solution: plasmolysis. Hypotonic: turgor. At incipient plasmolysis, ψp=0.
Imbibition: uptake of water by solid colloids, such as seeds and wood.
Check yourself
Try each one on your own first. If you are stuck, open a hint. Then check with Show the answer.
What is the water potential of pure water at the pressure of the air?
A cell has ψs=−1.2MPa and ψp=0.5MPa. What is its water potential?
What fills the space between the wall and the protoplast of a plasmolysed cell?
What is the solute potential of 0.2mol/L sucrose at 298K?
Why does a plant cell in pure water not burst, while a red blood cell does?
References
Taiz, Zeiger, Møller and Murphy, Plant Physiology and Development, 6th edition, chapter 3, Water and Plant Cells.
OpenStax Biology 2e, chapter 30, Plant Form and Physiology, section 30.5 Transport of Water and Solutes in Plants.
NCERT (2006). Biology, Textbook for Class XI, chapter 11, Transport in Plants.
Enroll free in Water Potential, Osmosis and Uptake by Roots
Every lesson is open to read. Enrolling also lets you:
Mark lessons done and carry on where you stopped.
Take the tests of this lesson and its course.
Count the course towards the certificate for its chapter.