A sweet mango hangs far from the leaves that made its sugar. This lesson shows how sugar moves in the phloem from a source to a sink, the experiments that prove the phloem carries it, and how the pressure flow hypothesis explains the movement.
about 30 min1 simulation1 practice question
Lesson 3 of 3Show all lessonsHide
Try the code and the simulations beside the lesson.
Sugar on the move
A leaf makes sugar in sunlight. A root deep in the soil, a growing shoot tip and a ripening fruit all need it. So the sugar must travel. It moves in the phloem, and its movement is called translocation.
The phloem sap is mostly sucrose, dissolved in water. It also carries amino acids, hormones and some mineral ions, such as potassium. Why sucrose and not glucose? Sucrose is a non-reducing sugar. It reacts less on the way, so it arrives as it left.
The cells of the phloem
Sieve tube elements join end to end to form sieve tubes. Their end walls are sieve plates, full of pores. A mature sieve tube element is alive but has no nucleus and few organelles, so sap flows through it easily.
Companion cells sit beside the sieve tubes and are joined to them by many plasmodesmata. They have a nucleus and many mitochondria. They keep the sieve tube alive and help load the sugar.
Phloem parenchyma and phloem fibres store food and give support.
When a sieve tube is damaged, its sieve plates are sealed quickly with a carbohydrate called callose. This stops the sap leaking out.
Source and sink
A source is a part that makes sugar or releases it from storage. A sink is a part that uses or stores it. A mature leaf is the usual source. Roots, fruits, seeds and young leaves are sinks.
The roles can change. In spring, a potato tuber or the root of a sugar beet sends stored sugar to new shoots, so it is a source. Later in the year it fills up again, as a sink. So the phloem can carry sugar up or down, depending on where the sources and sinks are. In different sieve tubes, sap can even move in opposite directions in the same stem. The xylem, by contrast, carries water only upward.
Feature
Xylem
Phloem
Carries
water, minerals
sucrose, amino acids
Direction
upward only
up or down
Cells
dead (vessels)
living (sieve tubes)
Driving force
tension from above
pressure from source
The evidence
Girdling. Remove a ring of bark, which holds the phloem, from a woody stem, and leave the wood (xylem) intact. After some weeks the bark just above the ring swells, because sugar coming down piles up there. The part below it is starved. The leaves stay green at first, because water still rises in the wood. This old experiment showed that food moves down in the bark.
A woody stem before and some weeks after a ring of bark is removed. In the second drawing the ring exposes the wood (xylem) only; the bark just above the ring is swollen, and the part below it is thin. Arrows show sugar moving down in the bark and stopping at the ring, while water still moves up in the wood across the ring.
Aphids. An aphid feeds by pushing its mouthparts (the stylet) into a single sieve tube. If the insect is cut away, sap keeps oozing from the stylet for hours. This shows the sap is under pressure, and it lets scientists collect pure phloem sap.
Radioactive tracers. A leaf given carbon dioxide made with radioactive carbon makes labelled sugar. The label later turns up in the phloem and in the sinks, above and below the leaf.
The pressure flow hypothesis
How does the sap move? The accepted model is the pressure flow (or mass flow) hypothesis, put forward by Ernst Münch in 1930.
A model of pressure flow. On the left a leaf cell, the source, loads sucrose into a sieve tube; water enters the sieve tube from the xylem beside it, so the pressure there is high. A long sieve tube runs to the right, to a root cell, the sink, which takes sucrose out; water leaves the sieve tube there, so the pressure is low. Thick arrows in the sieve tube show sap flowing from high to low pressure. A xylem vessel runs alongside, carrying water back from the sink end to the source end.
Loading at the source. Sucrose is moved into the sieve tubes, often against its gradient. In many plants a proton pump in the companion cells pushes hydrogen ions out, and sucrose comes back in with them through a symport. This uses ATP, so loading is active.
Water enters. The sucrose lowers the water potential in the sieve tube. Water enters by osmosis from the xylem beside it. The pressure potential (turgor) in the sieve tube rises.
Flow. At the sink, sucrose is taken out. The water potential rises, water leaves the sieve tube, and the pressure falls. So the pressure is high at the source and low at the sink. The sap flows by bulk flow, from high to low pressure, along the sieve tube.
Unloading at the sink. Sucrose leaves the sieve tube and is used or stored, often as starch. The water returns to the xylem.
The phloem sap moves fast, often about a metre in an hour. That is far faster than diffusion could manage.
Set the two sucrose sliders equal. The difference falls to zero, and the model says the flow stops. A sink keeps the flow going only by taking the sugar away.
Not everything is settled. Scientists still debate how a pressure difference can push sap through the many sieve plates of a very tall tree. But the pressure flow model fits most of the evidence.
Try it in Python
The program sorts the parts of a potato plant into sources and sinks in two seasons.
Practise with new numbers
Common mistakes
Saying the phloem carries glucose. It carries mostly sucrose.
Saying phloem flow is only downward. It goes from source to sink, up or down.
Calling sieve tubes dead. They are living but have no nucleus. Xylem vessels are dead.
Forgetting that loading uses energy. Sucrose is loaded actively at the source.
Saying the girdled tree dies at once. The roots starve slowly; the leaves stay green while the xylem still carries water.
Remember these
Phloem: sieve tubes (living, no nucleus), companion cells, sieve plates sealed by callose.