Try it on paper first. A hint, the key idea and the worked solution are here when you need them.
Extended question. The Haber process runs at kPa. The Contact process runs at kPa. In both, the forward reaction is exothermic and a higher pressure would move the position to the right. (a) How many times bigger is the pressure of the Haber process? (b) Explain why a very high pressure is used in the Haber process. (c) Explain why it is not used in the Contact process. (d) Explain why both processes use and not a much lower temperature.
Haber: , 450 °C, 20 000 kPa, iron catalyst. Contact: , 450 °C, 200 kPa, vanadium(V) oxide catalyst. Both forward reactions are exothermic. The conditions are a compromise between the rate, the position of equilibrium, the cost and the safety. Moles .
Have you tried it?
Work it out on paper first. It is fine to get stuck or make a mistake: that is how we learn. When you are ready, go through the solution one step at a time, and check each step against your own.
Step 1. The ratio. .
Step 2. The Haber process. There are 4 gas molecules on the left and 2 on the right. A high pressure moves the position to the right and gives a bigger yield of ammonia. It also makes the reaction faster. The yield at a low pressure would be too low.
Step 3. The Contact process. There are 3 gas molecules on the left and 2 on the right, but the yield at kPa is already very high. A much higher pressure would add the cost of strong equipment and pumps, and more danger from the hot, corrosive gases, for very little more sulfur trioxide.
Step 4. The temperature. A lower temperature would give a better yield, because the forward reactions are exothermic. But the rate would be far too slow. with a catalyst is a compromise between rate and yield.
Answer: The pressure of the Haber process is 100 times bigger. A high pressure is needed for a good yield in the Haber process but not in the Contact process. is a compromise between the rate and the yield.
Check. In atmospheres, as well.
Log in to join the discussion.
Loading…