Expansion, Heat Capacity and Changes of State: Quick Revision
A brief note on Expansion, Heat Capacity and Changes of State. It covers thermal expansion, internal energy, specific heat capacity, melting, boiling and evaporation, with a worked example and questions to check yourself.
A brief note on Expansion, Heat Capacity and Changes of State. Read it before a test. Try each question at the end before you open its answer.
Thermal expansion
Solids, liquids and gases expand when heated and contract when cooled. A gas must be at constant pressure.
The particles move further apart. They do not get bigger.
Gases expand most, then liquids, then solids. Extended: the forces between the particles explain the order.
Uses and effects: gaps in bridges and rails, slack overhead cables, liquid-in-glass thermometers, a loose lid, cracked glass, the bimetallic strip.
Specific heat capacity
Internal energy rises when temperature rises. Extended: the average kinetic energy of the particles rises.
Extended:c=mΔθΔE, so ΔE=mcΔθ. The unit is J/(kg °C).
Extended: to measure c, use ΔE=VIt, the mass and the rise in temperature. Heat loss makes the calculated c too large.
Melting, boiling and evaporation
Energy goes in and the temperature stays the same during melting and boiling. Water: 0∘C and 100∘C at standard atmospheric pressure.
Condensation and solidification: the particles lose energy and slow down.
Evaporation: the fast particles escape from the surface, so the liquid cools.
Extended: boiling is at one temperature and throughout the liquid. Evaporation is at any temperature and at the surface. A higher temperature, a bigger surface and moving air speed it up.
A worked example
How much energy warms 0.80 kg of water by 30∘C? And how much does a copper-like rail of length 18 m grow if one metre grows by 1.7 mm for 100∘C and the temperature rises by 40∘C?
Energy.ΔE=mcΔθ=0.80kg×4200J/(kg °C)×30∘C=100800J.
Growth.1.7×18×10040=12.24mm.
Check yourself
Why does the temperature stay constant while a solid melts?
Name two things that make evaporation faster.
Why is the measured specific heat capacity too large when energy is lost to the air?