An X-ray tube speeds electrons up through tens of kilovolts and stops them in a tungsten target. Only about 1% of their energy becomes X-rays. The spectrum is a smooth curve that ends at λmin=hc/(eV)
Lesson 1 of 3Show all lessonsHide
Try the code and the simulations beside the lesson.
Light that passes through you
Hold your hand up to a bright torch and the fingers glow red at the edges, but you cannot see the bones. X-rays are light of very short wavelength, from about 0.01 nm to 1 nm. They pass through soft tissue much more easily than through bone. So a beam that has gone through a hand carries a shadow of its bones. That is the X-ray picture, called a radiograph.
How do we make X-rays? We stop very fast electrons.
The X-ray tube
A labelled drawing of an X-ray tube. On the left a heated filament, the cathode, gives off electrons. A high voltage of tens of kilovolts between the cathode and the anode on the right speeds them up across a vacuum inside a glass envelope. The anode is a tungsten disc set at a slant on a spinning shaft driven by a motor. X-rays leave the spot where the electrons hit, through a thin window at the bottom, and pass through an aluminium filter. Oil around the tube carries the heat away, and a lead housing stops X-rays going in other directions.
The cathode is a heated filament. Hot metal gives off electrons. This is thermionic emission.
The accelerating voltage, from about 20 kV to 150 kV, speeds the electrons across a vacuum. Each electron arrives with a kinetic energy eV.
The anode is a target of tungsten. Tungsten has a large atomic number, which makes X-rays well, and a very high melting point, 3422∘C.
Most of the energy becomes heat. Only about 1% of the energy of the electrons becomes X-rays. So the anode spins, to spread the heat around a ring, and oil around the tube carries the heat away.
A lead housing stops X-rays except through a window. A collimator shapes the beam to the part being imaged.
Two kinds of X-ray
An electron that dives into the target is slowed by the electric fields of the nuclei. A charge that slows down gives out light, and here the light is X-rays. This is braking radiation, also called bremsstrahlung. One electron may lose its energy in many small steps or in one large one. So the photons have every energy up to a largest value, and the spectrum is continuous.
The largest energy comes when one electron gives all of its energy eV to one photon. Then eV=hfmax=hc/λmin, and we want λmin:
λmin=eVhc
A handy form is hc/e=1239.8 nm V. So λmin in nanometre is 1239.8 divided by the voltage in volt.
The second kind are characteristic lines. A fast electron can knock an electron out of an inner shell of a tungsten atom. An outer electron drops into the gap and gives out a photon of one exact energy. For tungsten the strongest lines are near 59 keV and 67 keV. They appear only when eV is larger than the energy needed to empty the inner shell.
A graph of the X-ray intensity against the photon energy, from 0 to 110 kiloelectronvolt, for a tube at 100 kilovolt with a tungsten target. A smooth hump of braking radiation starts near 15 kiloelectronvolt, peaks near 42 and falls in a straight line to zero at exactly 100 kiloelectronvolt, the largest energy one electron can give. Two sharp, tall spikes stand on the hump at about 59 and 67 kiloelectronvolt, labelled the characteristic K lines of tungsten. A dashed curve shows the low-energy end cut away more strongly after a thicker aluminium filter.
Worked example: an 80 kV tube
A tube runs at 80 kV with a current of 5.0 mA. Find the shortest wavelength, the number of electrons each second, and the heat in the anode.
Shortest wavelength.λmin=80000V1239.8nm V=0.0155 nm, which is 15.5 pm.
Electrons each second.eI=1.602×10−19C5.0×10−3A=3.12×1016.
The power.P=IV=5.0×10−3A×80000V=400 W.
The heat. With about 1% as X-rays, 4 W leave as X-rays and about 396 W heat the anode.
Check. A photon of 15.5 pm has an energy of 80 keV, the energy of one electron. It fits.
Current and voltage do different jobs
The tube current sets the number of electrons, so it sets the number of photons. It does not change the shape of the spectrum.
The tube voltage sets the largest energy. A higher voltage gives a harder beam, with more photons of high energy that pass through thicker parts of the body. It also makes many more photons, since the output rises steeply with the voltage.
A radiographer chooses a higher voltage for a thick part, such as the abdomen, and a lower one for a hand.
Filtering the beam
Photons of low energy are absorbed in the first centimetre of skin. They add to the dose and do nothing for the picture. A thin sheet of aluminium at the window absorbs most of them. The beam that is left has a higher average energy. We say the filter hardens the beam.
Set the voltage to 50 kV and then to 100 kV. Where does the curve end each time? Now set the filter to 0 and then to 6 mm. Which end of the spectrum changes most?
Practise with new numbers
Try it in Python
The program finds the shortest wavelength, the electrons each second and the share of heat for three tube voltages.
Common mistakes
Mixing up current and voltage. The current sets how many photons. The voltage sets how energetic they can be.
Leaving the voltage in kilovolt in λmin=hc/(eV). Change it to volt first.
Thinking all the photons have the energy eV. That is only the largest energy. Most photons have much less.
Forgetting the heat. About 99% of the power heats the anode.
Remember these
Thermionic cathode, accelerating voltage, tungsten anode, vacuum, lead housing.
λmin=hc/(eV), and hc/e=1239.8 nm V.
A continuous spectrum of braking radiation, with characteristic lines of the target.
Current: number of photons. Voltage: hardness and number.
An aluminium filter removes soft photons and hardens the beam.
Check yourself
Try each one on your own first. If you are stuck, open a hint. Then check with Show the answer.
Why is the target of a tube made of tungsten?
A tube is changed from 60 kV to 120 kV. What happens to its shortest wavelength?
Why does a tube need cooling, when X-rays carry so little energy?
What does an aluminium filter do to the average energy of the photons in the beam?
References
OpenStax University Physics Volume 3, Chapter 8 Atomic Structure, on atomic spectra and X-rays.
Cambridge International AS and A Level Physics (9702) syllabus, Medical physics, production and use of X-rays.
Enroll free in X-Ray Imaging, CT and MRI
Every lesson is open to read. Enrolling also lets you:
Mark lessons done and carry on where you stopped.
Take the tests of this lesson and its course.
Count the course towards the certificate for its chapter.