Ultrasound is sound above 20 kHz. A piezoelectric crystal makes short pulses of it at a few megahertz and also hears the echoes. How strong an echo is depends on the acoustic impedance Z=ρc on each side of a boundary.
about 35 min
Lesson 1 of 3Show all lessonsHide
Try the code and the simulations beside the lesson.
Seeing with sound
A bat finds a moth in the dark by its echo. A ship finds the sea floor in the same way. A doctor can look at a baby before it is born, or at a heart valve as it opens, with the same idea. A short burst of sound goes into the body, and the echoes from each boundary come back.
The sound we use is ultrasound: sound with a frequency above 20 kHz, which is above what a human ear can hear. Medical scanners use 1 MHz to about 15 MHz. Why so high? A wave cannot show detail much smaller than its wavelength. In soft tissue sound travels at about 1540 m/s. At 3.0 MHz the wavelength is
λ=fv
λ=3.0MHz1540m/s
λ=0.51mm
So a scan at a few megahertz can show detail of about half a millimetre.
The piezoelectric transducer
The probe that touches the skin is a transducer. It changes electrical energy into sound and back again. Its heart is a thin disc of a piezoelectric crystal, such as quartz or lead zirconate titanate (PZT).
Sending. A potential difference across the crystal changes its thickness a little. An alternating potential difference makes it vibrate, and it sends out sound.
Receiving. An echo squeezes and stretches the crystal. The crystal then makes a small alternating potential difference, which the scanner amplifies.
The crystal vibrates most strongly at its resonant frequency, when its thickness is half the wavelength of sound inside the crystal. A backing block behind it damps the vibration quickly, so each pulse lasts only a few cycles. A short pulse lets us tell two close boundaries apart.
The same crystal sends a pulse, then listens for the echoes, then sends the next pulse. It spends far more time listening than sending.
A cut-away drawing of an ultrasound probe resting on the skin. At the top is a backing block, then a thin disc of piezoelectric crystal with an electrode on each face, wired to a pulse generator and an amplifier. Below the crystal is a thin matching layer and then a layer of coupling gel on the skin. Arrows show a short pulse going down into soft tissue and an echo coming back up from a boundary between fat and muscle.
Acoustic impedance
Why does a boundary reflect sound at all? Each material resists being set into vibration by a sound wave in its own way. We measure this with the specific acoustic impedanceZ:
Z=ρc
Here ρ is the density and c is the speed of sound in the material. The unit of Z is kg m−2s−1. Some typical values follow.
Material
Z in 106kg m−2s−1
air
0.00043
fat
1.34
soft tissue
1.63
muscle
1.71
bone
7.75
They come from densities and speeds such as 925kg/m3 and 1450 m/s for fat, or 1900kg/m3 and 4080 m/s for bone.
How much is reflected
When the wave meets a boundary at right angles, the share of the intensity that comes back is the intensity reflection coefficient:
α=I0IR
α=(Z2+Z1)2(Z2−Z1)2
The rest, 1−α, goes on into the second material. Notice three things.
If Z1=Z2, nothing is reflected. The boundary is invisible to sound.
The bigger the difference in Z, the stronger the echo.
Swapping the two materials does not change α.
Worked example: fat on muscle, and air on skin
Find the share reflected at a fat to muscle boundary, and at an air to soft tissue boundary.
Fat to muscle.Z2−Z1=(1.71−1.34)×106 and Z2+Z1=(1.71+1.34)×106, in kg m−2s−1. So α=(0.37/3.05)2=0.0147, about 1.5%.
Air to tissue. Here Z1=430kg m−2s−1 is tiny next to Z2=1.63×106kg m−2s−1. The ratio is (1.63×106−430)/(1.63×106+430)=0.99947. So α=0.9989, which is 99.9%.
Check. The echo from fat on muscle is weak, but it is enough to see. Almost no sound gets across a layer of air.
Why we use a gel
The second result explains the cold gel that a sonographer spreads on the skin. Without it, a thin layer of air sits between the probe and the skin. That layer would reflect 99.9% of the sound, both on the way in and on the way out. The gel has an impedance close to that of skin, so it couples the probe to the body and almost all of the sound goes in. Matching the impedance is called impedance matching.
The same reason explains why ultrasound cannot see behind bone or through the air in the lungs. At these boundaries most of the sound is reflected, and what goes on is weak.
Set both impedances to 1.63. What is reflected? Now move the second one up to 7.75, like bone. Is the curve steeper close to Z1 or far from it?
Practise with new numbers
Try it in Python
The program finds the impedance of four materials and the share reflected at three boundaries.
Common mistakes
Forgetting to square. The share of the intensity is the square of (Z2−Z1)/(Z2+Z1).
Mixing up density and impedance. Bone reflects strongly because both its density and its speed of sound are large.
Thinking the gel is for comfort. It removes the layer of air, which would reflect almost everything.
Using the speed of sound in air. In soft tissue the speed is about 1540 m/s, nearly five times larger.
Remember these
Ultrasound is above 20 kHz. Medical scans use 1 to 15 MHz, so the wavelength is under a millimetre.
A piezoelectric crystal both sends and receives. A backing block keeps the pulses short.
Z=ρc, in kg m−2s−1.
α=(Z2−Z1)2/(Z2+Z1)2. Equal impedances give no echo.
Coupling gel matches the probe to the skin.
Check yourself
Try each one on your own first. If you are stuck, open a hint. Then check with Show the answer.
Why must a scanner send short pulses, and not a steady sound?
Two tissues have the same impedance. What does a scan show at their boundary?
What is the acoustic impedance of a material with a density of 1000kg/m3 and a speed of sound of 1500 m/s?
Why does a scan of the abdomen not show what lies behind the lungs?
References
OpenStax College Physics 2e, Chapter 17 Physics of Hearing, section 17.7 Ultrasound.
Cambridge International AS and A Level Physics (9702) syllabus, Medical physics, production and use of ultrasound.
Enroll free in Ultrasound, Hearing and Sight
Every lesson is open to read. Enrolling also lets you:
Mark lessons done and carry on where you stopped.
Take the tests of this lesson and its course.
Count the course towards the certificate for its chapter.