How do we know that salt is rock salt and copper is fcc? Nobody can see atoms with a lens. In 1912 X-rays were found to scatter from crystals into sharp spots, and the next year William Lawrence Bragg explained why with one simple equation. We derive Bragg's law, meet the planes of a crystal and their Miller indices, and find the spacing of planes in a cubic cell.
about 30 min1 simulation2 practice questions
Lesson 1 of 3Show all lessonsHide
Try the code and the simulations beside the lesson.
Why X-rays?
Light bends round an obstacle or through a grating only when the spacing is close to its wavelength. Atoms in a crystal are about 200 to 500pm apart. Visible light, at 400 to 700nm, is a thousand times too long. X-rays have wavelengths near 100pm, the right size. So a crystal acts as a three-dimensional grating for X-rays.
Most laboratories use the X-rays from a copper target, called Cu K-alpha, with λ=154.06pm. A molybdenum target gives Mo K-alpha, λ=71.07pm.
Bragg's picture
Bragg thought of the crystal as stacks of parallel planes of atoms, each a distance d from the next. A beam of X-rays meets the planes at a glancing angle θ. Each plane reflects a little of the beam, as a mirror would, at the same angle θ.
Two parallel horizontal rows of atoms, a distance d apart. Two parallel X-ray beams come in from the upper left at an angle theta to the rows. The first reflects from the top row and the second from the row below. Both leave at the same angle theta. Two short red segments mark the extra path of the lower ray, each of length d sin theta, so the extra path is 2d sin theta. A label says the waves add when 2d sin theta equals n lambda.
The ray that reflects from the second plane travels farther than the ray from the first. The extra path is dsinθ on the way in and dsinθ on the way out, 2dsinθ in all. The two reflected waves add up, and give a strong beam, only when this extra path is a whole number of wavelengths:
nλ=2dsinθ
This is Bragg's law. The whole number n is the order of the reflection. At any other angle, the waves from the many planes cancel out, and nothing comes out. That is why a crystal gives sharp spots, not a smear.
Note the angle. θ is measured from the plane, not from the normal as in optics. The beam turns through 2θ in all, and a diffractometer records the angle 2θ.
Using the law
Example. In sodium chloride the planes parallel to a cube face are 282.0pm apart. Copper X-rays reflect from them in the first order at
sinθ=2dλ=2×282.0pm154.06pm=0.2732
So θ=15.85∘, and the detector sits at 2θ=31.70∘.
How many orders? Since sinθ cannot pass 1, the order is at most n≤λ2d. For these planes, 154.062×282.0=3.66, so orders 1, 2 and 3 appear.
The second order from planes d apart is the same as a first-order reflection from planes d/2 apart, since 2λ=2dsinθ means λ=2(d/2)sinθ. So crystallographers often fold the order into the planes and write λ=2dsinθ.
Planes and their Miller indices
A crystal holds many sets of planes, in many directions. We name a set by its Miller indices(hkl):
Find where one plane cuts the three axes, in units of the cell edges a, b and c.
Take the reciprocals of the three numbers. A plane parallel to an axis cuts it at infinity, and the reciprocal is 0.
Clear any fractions to get the smallest whole numbers.
Example. A plane cuts the axes at 2a, 3b and parallel to c. The reciprocals are 21, 31 and 0. Multiply by 6: (320).
The faces of the cube are the (100) planes. The planes that cut two axes at a and run parallel to the third are (110). The planes that cut all three axes at a are (111). A minus sign is written as a bar over the number. Some books write it as a minus sign in front, such as (11ˉ0).
The spacing of cubic planes
In a cubic cell of edge a, the planes (hkl) are
dhkl=h2+k2+l2a
apart. So d100=a, d110=2a, d111=3a and d200=2a. The higher the indices, the closer the planes, and the larger the angle of their reflection. The integer h2+k2+l2 is the key to the next lesson.
For NaCl above, the 282.0pm planes are d200, since a=564.0pm. A-Level and IB courses do not ask for Miller indices. The olympiads and university courses do.
Set the NaCl planes, d=282pm, and copper X-rays. Then raise the order to 4. The reflection is gone, because 4λ is more than 2d.
Practise with new numbers
Try it in Python
The program finds the Bragg angle and 2θ for each order that a set of planes allows, and the spacing of several cubic planes.
Common mistakes
Measuring θ from the normal. In Bragg's law θ is the glancing angle, measured from the plane.
Dropping the 2. The path difference is 2dsinθ.
Reading 2θ as θ. A diffractometer gives 2θ. Halve it before you use Bragg's law.
Forgetting the limit on the order.n cannot be larger than 2d/λ.
Using the intercepts as the indices. Take the reciprocals first, then clear the fractions.
Remember these
Bragg's law: nλ=2dsinθ, with θ from the plane.
Cu K-alpha: 154.06pm. Mo K-alpha: 71.07pm.
Highest order: n≤2d/λ.
Miller indices: reciprocals of the intercepts, cleared to whole numbers.
Cubic spacing: dhkl=a/h2+k2+l2.
Check yourself
Try each one on your own first. If you are stuck, open a hint. Then check with Show the answer.
Copper X-rays reflect in the first order from planes at θ=18.0∘. How far apart are the planes?
What are the Miller indices of a plane that cuts the axes at a, 2b and 2c?
A cubic crystal has a=400pm. Find d111 and d220.
Why can visible light not show the arrangement of atoms in a crystal?
A reflection is found at 2θ=50.0∘ with copper X-rays. What is sinθ?
References
OpenStax, Chemistry 2e, Chapter 10, section 10.6, the part on X-ray crystallography and Bragg's equation.
The Cu K-alpha and Mo K-alpha wavelengths are the standard weighted mean values used by crystallographers.
Enroll free in X-ray Diffraction and Crystal Calculations
Every lesson is open to read. Enrolling also lets you:
Mark lessons done and carry on where you stopped.
Take the tests of this lesson and its course.
Count the course towards the certificate for its chapter.