Measuring Rates and Collision Theory: Quick Revision
A brief note on Measuring Rates and Collision Theory: the meaning of rate, two ways to measure it, rate graphs, collision theory and judging a method. With a worked example, practice, a program and questions to check yourself.
A brief note on Measuring Rates and Collision Theory. Read it before a test. Try each question at the end before you open its answer.
Rate and how to measure it
Rate = amount of product formed (or reactant used up) ÷ time taken. Units: cm³/s, g/s, g/min or mol/s.
A gas can be followed by its volume in a gas syringe, or by the loss of mass of the flask on a balance.
A reaction slows down as the reactants are used up. A mean rate is the average over an interval.
Hydrogen is too light for a balance. Use a gas syringe.
Rate graphs
On a volume against time graph, the gradient is the rate. A tangent gives the rate at one moment.
Steep means fast. Flat means finished: one reactant, the limiting reactant, is used up.
The end height shows the amount made. It does not show the rate.
One mole of any gas fills 24000cm3 at room temperature and pressure.
Collision theory (Extended)
Particles must collide to react, but only collisions with at least the activation energy, Ea, are successful.
Ea is the height from the reactants to the top of the peak on the energy profile.
The rate depends on the particles per unit volume, the frequency of collisions, their kinetic energy and Ea.
Judge a method for accuracy. Repeat, take a mean, and keep the other variables the same.
A worked example
1.0 g of marble reacts with excess acid, and the gas syringe is read every 30 s. It reads 0, 48 and 72cm3 at 0, 30 and 60 s. Find the mean rate in each interval.
First interval.48÷30=1.6cm3/s.
Second interval.(72−48)÷30=0.80cm3/s.
Compare. The rate falls to half, because reactant is used up.
Practice with new numbers
A program to try
The function gives the mean rate between two readings.
Mistakes to avoid
Dividing the time by the volume. The volume goes on top.
Reading the height as the rate. The slope is the rate.
Saying that every collision reacts. Only collisions with at least Ea do.
Using a balance for hydrogen. The mass change is too small.
Check yourself
What does a flat line on a volume against time graph show?
A tangent rises by 20cm3 over 50 s. What is the rate?
What is activation energy?
Sources
Cambridge IGCSE Chemistry 0620 syllabus for 2026 to 2028, section 6.2.
OpenStax, Chemistry 2e, Chapter 12, sections 12.1 and 12.5.