A brief note on automated systems: what sensors, microprocessors and actuators do, the control loop and feedback, and the advantages and disadvantages to weigh in a scenario. With practice, a program and questions to check yourself.
A brief note on Automated Systems. Read it before a test. Try each question at the end before you open its answer.
The three parts
Sensor. Measures a physical quantity, such as temperature, light or moisture, and sends the data. An ADC turns an analogue signal into digital data.
Microprocessor. Compares the data with stored values, decides, and sends signals to the actuators. It is usually part of an embedded system.
Actuator. Turns a signal into a physical movement: a motor, a pump, a valve or a solenoid.
The control loop
Read the sensor.
Compare the reading with the stored values.
Decide, and signal the actuator if a change is needed.
Repeat, for as long as the system runs.
Feedback. What the actuator does changes the next sensor reading, so the system corrects itself. Two stored values (on below one, off above the other) stop an actuator from switching too often.
Settings to know
Industry, transport, agriculture, weather, gaming, lighting and science. For each, be ready to name the sensors, what is compared, and the actuators.
Weighing a scenario
Advantages: works all the time; fast and consistent; safer for people; saves water, energy or materials; fewer staff.
Disadvantages: costly to set up and maintain; can fail or be hacked; cannot cope with the unexpected; jobs can be lost.
Tie every point to the scenario you are given.
Practice with new numbers
A program to try
The program is a fridge door alarm. A magnetic sensor reports each second whether the door is open. The buzzer sounds once the door has been open for more than three seconds in a row.
Mistakes to avoid
The sensor decides. Only the microprocessor decides.
No comparison. Always say "compares the reading with a stored value".
No repeat. A control system keeps reading the sensor.
General points. Advantages and disadvantages must fit the scenario.
Check yourself
Name the actuator that could open a greenhouse window.
A heater is off. It comes on below 17∘C and goes off above 21∘C. The reading is 17∘C. What happens?
Give one reason why a sensor reading must pass through an ADC.
Give one advantage and one disadvantage of an automatic lighting system in a school.
Sources
Cambridge International, IGCSE Computer Science 0478 syllabus for 2026 to 2028, unit 6.1 (automated systems) and unit 3.2 (sensors).